Excessive processing times
OK so to be honest I'm not sure if I'm posting in the correct location. I am using ANSYS to simulate a particle impacting a plate, I followed a detailed tutorial on YouTube on how to simulate it and it's all well and good, the meshing is not extremely fine but the solving time hits 9 hours, is there something I can change to lessen the solving time?
Thanks Al |
You have to post it in CFX or Fluent forum.
Anyway Solving will take time especially with particles. And also it depends upon the number of HPC licences you have. |
Thanks for the reply, I managed to reduce the time significantly to a matter of minutes by reducing the analysis time, I realised I didn't need such a long analysis time.
Thanks |
All times are GMT -4. The time now is 02:40. |