|
[Sponsors] |
[ANSYS Meshing] interface wrongly identified as well |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 12, 2014, 04:13 |
interface wrongly identified as well
|
#1 |
New Member
Ahirekar Prasanna P
Join Date: Aug 2013
Posts: 15
Rep Power: 12 |
Hii Guys,
I am meshing 360 degree model of combustor for my project in ICEM CFD. I started with meshing 20 degree geometry meshed it with required quality then I simply rotated the mesh to get 360 degree mesh. But the problem that I am facing now is I had created walls on sides to mesh 20 degree mesh and in 360 degree mesh thais interface is getting detected as a wall which is wrong.I even tried with deleting these face but the mesh shows uncovered faces so please help me in this regerd. I am attaching ICEM CFD file and also FLUENT file which shows the problem.Please suggest me some suitable way to tackle with the problem.Thank you in advance |
|
April 30, 2014, 14:19 |
|
#3 |
New Member
Ahirekar Prasanna P
Join Date: Aug 2013
Posts: 15
Rep Power: 12 |
Hii Far
Which files I need to upload?? |
|
May 1, 2014, 01:20 |
|
#5 |
New Member
Ahirekar Prasanna P
Join Date: Aug 2013
Posts: 15
Rep Power: 12 |
I am not able to upload tin file as it is showing errors. Can u give me your email address so I can send through email
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |