[ICEM] Pre-mesh sizing not following edge parameter -- CFD Online Discussion Forums

August 29, 2018, 08:37

Pre-mesh sizing not following edge parameter

simonmcintyre

New Member

Simon

Join Date: Aug 2018

Posts: 2

Rep Power: 0

simonmcintyre is on a distinguished road

Hi,

I've run into a problem creating my mesh. For some reason the pre-mesh calculated doesn't follow the edge parameters I've specified.

In the attached image the sizing parameters are in red, and the generated pre-mesh in green.

Can anyone shed some light on what might be happening, there are no conflicting sizing rules that I can see.

Thanks

Attached Images

EdgeSizing.PNG (31.3 KB, 32 views)

Tags

edge sizing, icem, parameters

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[snappyHexMesh] sHM layer process keeps getting killed	MBttR	OpenFOAM Meshing & Mesh Conversion	4	August 15, 2016 03:21
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06

All times are GMT -4. The time now is 12:21.