|
[Sponsors] |
May 11, 2014, 16:15 |
ICEM meshing
|
#1 |
Senior Member
Ali reza
Join Date: Mar 2014
Posts: 110
Rep Power: 12 |
hello
I am completely amateur in ICEM I have imported a geometry with .stl format which is like a curved pipe to ICEM and I don't know how to mesh and define boundary conditions, PLEASE help me .It shows that it is just one surface but I need to have 3 boundary conditions for inlet,outlet and wall and I am looking for good mesh and boundaries. if there any one who can help? |
|
May 12, 2014, 05:29 |
|
#2 |
Member
SanS
Join Date: Mar 2009
Posts: 41
Rep Power: 17 |
I don't think anyone would have the time to list down the entire procedure. Have you completed a few tutorials in ICEM?
|
|
May 12, 2014, 05:37 |
|
#3 |
Senior Member
Ali reza
Join Date: Mar 2014
Posts: 110
Rep Power: 12 |
thanks for your attention
you are absolutely right but I am in a big rush and I just need important few steps to do that because I am using Gambit and in this case somehow it is not capable . I have seen some tutorials about ICEM on the web but non of them was relevant to my geometry If you know any tutorial please share it. thank you |
|
May 12, 2014, 08:45 |
|
#4 | |
Senior Member
Daniel
Join Date: Mar 2013
Location: Noshahr, Iran
Posts: 348
Rep Power: 21 |
Quote:
It has a tutorial called "Tetra/Prism Mesh Generation for an Aorta" which is close to what you need. Tetra/Prism Mesh Generation is the easiest method which you can learn by going through that tutorial. Best wishes D. Khazaei |
||
May 12, 2014, 15:54 |
|
#5 |
Senior Member
Ali reza
Join Date: Mar 2014
Posts: 110
Rep Power: 12 |
It is really helpful
thanks for your help and support regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Complex .stl data for volume meshing in ICEM CFD | Nils_H | ANSYS Meshing & Geometry | 5 | September 2, 2011 08:39 |
Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 09:16 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
[ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
ICEM meshing question | gsbhatia89 | ANSYS Meshing & Geometry | 5 | June 14, 2010 08:24 |