|May 28, 2014, 03:20||
Before using boolean VS after using boolean !
Join Date: Oct 2013
Posts: 366Rep Power: 7
I'm working on a centrifugal compressor for analysis in fluent
The compressor has 20 impellers and I'm modelling just 1/20 of whole model
So I'm modeling the air path and then use boolean to Subtract compressor from air
Before using the boolean the side surfaces of air model have equal area but when I'm trying boolean the number of the edges are the same but the surfaces area are difference!
How can I solve this problem?
|Thread||Thread Starter||Forum||Replies||Last Post|
|FLUENT not running||CFDFRED||ANSYS||4||June 10, 2016 15:26|
|Fluent does not launch from workbench||NickyNac||FLUENT||4||November 13, 2015 10:06|
|[ansys fluent] problems of running ANSYS 12.1 fluent module||mkwang2006||FLUENT||3||September 30, 2013 10:59|
|Local Parallel Processing||Magma||CFX||9||April 26, 2013 07:24|
|Info message -> Fluent does not start||Jenson||FLUENT||0||December 22, 2011 18:21|