CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] How to mesh my 3D geometries correctly

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   June 3, 2014, 02:04
Default How to mesh my 3D geometries correctly
  #1
Member
 
CR-7
Join Date: Jun 2011
Location: Malaysia
Posts: 66
Rep Power: 14
Heat Pipe is on a distinguished road
Hello

Regarding to my concentric and eccentric . I have read and downloaded many papers and tutorials about and my knowledge now is better. but have some specific quires:

1- What is the advantage from drawing sub volumes and 4-planes .

2- Periodic and wall ( Outer Wall ) what r the differences.


The main point is how to mesh my 3D geometries as in my drawing I have followed the next:

1- Volume>cylinder> draw two cylinders then subtract them.


now how to set my mesh (64X16X48) to get 49152 cells only , As firstly when I was drawing by sweep faces the no. of cells was 98400 by using same point above ,



Heat Pipe is offline   Reply With Quote

Old   June 3, 2014, 02:05
Default
  #2
Member
 
CR-7
Join Date: Jun 2011
Location: Malaysia
Posts: 66
Rep Power: 14
Heat Pipe is on a distinguished road
Heat Pipe is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[snappyHexMesh] problems generating clean mesh Christian_tt OpenFOAM Meshing & Mesh Conversion 2 June 20, 2019 06:39
3D Hybrid Mesh Errors DarrenC ANSYS Meshing & Geometry 11 August 5, 2013 07:42
[Gmsh] 2D Mesh Generation Tutorial for GMSH aeroslacker OpenFOAM Meshing & Mesh Conversion 12 January 19, 2012 04:52
engrid -> save as .stl with boundarie codes Zymon enGrid 31 August 29, 2011 14:40
fluent add additional zones for the mesh file SSL FLUENT 2 January 26, 2008 12:55


All times are GMT -4. The time now is 17:35.