Refinements in areas of interest
Hi everybody!
I am modeling a falling water film (2D) and I am trying to make refinements in the mesh where the water will be located. I have tried adding a "bounding box" for my refinements, and use these as boundaries for sizing. Problem is, when I use this method for my refinements I end up with two interior zones in FLUENT and that causes problems. Is there any way I can add refinements in Meshing without actually drawing it in Modeler? (Like blocking in ICEM?) Hope somebody can help me out! /Kristian |
All times are GMT -4. The time now is 14:14. |