Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Non-positive volume exist

Mark Forums Read

Reply

Search this Thread

August 14, 2014, 02:30	Non-positive volume exist	#1
amin.z Senior Member Amin Join Date: Oct 2013 Location: Germany Posts: 397 Rep Power: 14	Hi everyone! I'm facing a famous error! "Non-positive volume exist" I'm using ansys meshing for grid generation and then importing this mesh to fluent! But when I check the mesh, fluent says this error! I found some solution for GAMBIT and ICEM but for ANSYS MESHING there isn't any help! Do you have any suggestion for my problem!?? Best regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
Courant number blowing up, non-orthogonal mesh?	odellar	OpenFOAM Running, Solving & CFD	5	October 22, 2013 19:50
[ICEM] non positive volume	nabaen	ANSYS Meshing & Geometry	8	August 16, 2013 13:10
Non positive volume after solver settings	callofduty	FLUENT	0	April 8, 2009 04:50
[Commercial meshers] CuBit	t42	OpenFOAM Meshing & Mesh Conversion	6	July 10, 2008 07:51

All times are GMT -4. The time now is 15:19.