|
[Sponsors] |
August 21, 2014, 09:51 |
Link edge problem
|
#1 |
New Member
Tom
Join Date: Feb 2014
Posts: 4
Rep Power: 12 |
Hi All,
I am trying to mesh for a intake lip. As can be seen in the picture, the mesh is not following the half ellipse shape along the Z axis....I have tried link edge, associate edge to surface, link shapes but with no luck. I was hoping anyone who had met this problem before and could give me a hint please? Regards |
|
August 21, 2014, 10:18 |
|
#2 |
Senior Member
Join Date: Feb 2013
Location: Germany
Posts: 200
Rep Power: 24 |
You could also try associate face to surface or part. If that does not work create some more curves and points in z-direction and associate blocking to them.
|
|
August 21, 2014, 19:21 |
|
#3 | |
New Member
Tom
Join Date: Feb 2014
Posts: 4
Rep Power: 12 |
Quote:
Thanks for your kind reply. I did as your suggestion to draw two extra ellipses at symmetric position(some distance away from the initial ones) and associate edges with them, but between those two ellipses the mesh is still not following the shape. Any further suggestions? Regards |
||
August 22, 2014, 08:45 |
|
#4 |
Senior Member
Sebastian Engel
Join Date: Jun 2011
Location: Germany
Posts: 566
Rep Power: 20 |
Hi Tom,
did you check the association of the faces as suggested by kad? The screen shot shows some different colouring which corresponds to the associated part. That could be ok in your project. In a few projects, i had to reassociate some faces inside a blocking to thier right surface, sometimes also adjacent walls where i had problems with the mesh. With regards, Sebastian |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] low edge criterion value problem | mraxx | ANSYS Meshing & Geometry | 6 | April 30, 2013 10:03 |
[ICEM] Mutiple Edge problem | angierain | ANSYS Meshing & Geometry | 4 | August 3, 2011 12:38 |
Meshing problem trailing edge of blade | ben-18 | ANSYS Meshing & Geometry | 1 | July 13, 2011 11:39 |
Through-Flow solver, Leading-Trailing edge problem | Menander | Main CFD Forum | 0 | May 14, 2008 19:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |