|
[Sponsors] |
August 21, 2014, 05:24 |
3D Hemisphere Mesh Generation
|
#1 |
New Member
marcus lehmann
Join Date: May 2014
Posts: 3
Rep Power: 11 |
I've been trying to generate a good 3D mesh for a hemisphere on a flat plate, and found this tutorial.
https://www.youtube.com/watch?v=5vAKVVDF_P8 It explains the steps to getting the mesh working well, however, I'm having problems recreating the initial geometry. Are there any hints anyone has to regenerating that geometry? Thanks, Marcus |
|
August 21, 2014, 08:08 |
|
#2 |
Senior Member
Join Date: Feb 2013
Location: Germany
Posts: 200
Rep Power: 24 |
In general ICEM comes with all tutorial files. Maybe you just search for *.tin in your ANSYS installation directory.
|
|
August 21, 2014, 10:51 |
|
#3 |
Super Moderator
|
Just created primitive sphere in Design modeler, you can also do it in icem cfd. Again created enclosure with one symmetry plane at ZX. And here is the geometry. (generic) .
Here is the tetra mesh with prism boundary layer And here is the hexa mesh... |
|
August 21, 2014, 12:39 |
|
#4 |
Super Moderator
|
||
August 22, 2014, 03:24 |
|
#5 | |
New Member
marcus lehmann
Join Date: May 2014
Posts: 3
Rep Power: 11 |
Quote:
|
||
Tags |
icem 3d hemisphere |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[ANSYS Meshing] Question about mesh generation learning | lnk | ANSYS Meshing & Geometry | 2 | July 7, 2012 06:45 |
ISAAC code mesh generation | morteza08 | Main CFD Forum | 0 | June 15, 2012 09:26 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
General questions on grid-based computing | Adrin Gharakhani | Main CFD Forum | 21 | June 5, 2000 13:47 |