Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[GAMBIT] Two commands at a single line in Gambit journal

Mark Forums Read

Reply

Search this Thread

August 31, 2014, 09:01	Two commands at a single line in Gambit journal	#1
ferroburak New Member Burak Kaya Join Date: Nov 2011 Posts: 21 Rep Power: 15	Hi, Can I execute two commands at a single line in a Gambit journal? For example, I want to run, face mesh "volute" "impeller" pave size 2.5; face mesh "impeller" pave size 1.5 In a single line instead of two lines. Is this possible? Thanks in advance. Burak

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
whats the cause of error?	immortality	OpenFOAM Running, Solving & CFD	13	March 24, 2021 08:15
[OpenFOAM] Take derivative of mean velocity in paraFoam	hiuluom	ParaView	13	April 26, 2016 07:44
[OpenFOAM] could not open file .vtk in paraview	ali_atrian	ParaView	8	August 27, 2014 11:31
8x icoFoam speed up with Cufflink CUDA solver library	kmooney	OpenFOAM Running, Solving & CFD	42	November 6, 2012 12:37
Problems of Duns Codes!	Martin J	Main CFD Forum	8	August 15, 2003 00:19

All times are GMT -4. The time now is 16:51.