|
[Sponsors] |
November 7, 2013, 18:54 |
Match Edge - Copy Bunching not work!
|
#1 |
Member
Sheng
Join Date: Jun 2011
Posts: 62
Rep Power: 14 |
Dear all,
I come across a problem for a long time and now seek help from the forum. When using the Match Edge -- Copy bunching, I find what ever I choose the Reference Edge and the target edge, there is no change to the target edge. These two edges have the same number of nodes. "All Parallel" is not tried, because I only want specific edges to be copied to. Any hint? Regards Sheng |
|
September 2, 2014, 05:07 |
|
#2 |
New Member
Join Date: Jul 2014
Posts: 22
Rep Power: 11 |
Sorry fixed it now.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
[ICEM] Changing edge direction | la7low | ANSYS Meshing & Geometry | 2 | June 7, 2010 13:26 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
ICEM Extrude faces - Edge params. | Santiago Orrego. | CFX | 0 | June 19, 2007 12:08 |