Gambit meshing problem to following geometry
 

hi everyone, i'm having trouble meshing this geometry(picture attached). It is a part of a bigger geometry that i've divided into a several volumes.

In this volume, I've already mesh some faces and some edges. the meshing on the left side and upper side is from another volume. The face meshing on the back side, the obstruction inside the volume, and the edge meshing on the right side is my effort to create a structured volume mesh.

however, when i tried to mesh volume. An error message appeared : unexpected problems during submapping of volume 207.

Please, can anyone help me?

maybe is your volume 207 not suitable for hexa meshing.
I would try to copy this volume somewhere, and mesh it on the fly.
If you cannot, then it is not suitable for hexa meshing, and you need to split it
(I move your thread in the right subforum)

thanks for the reply

i have already succeded in meshing the volume. apparently, the volume need to be divided more so it can be meshed.