|
[Sponsors] |
September 14, 2014, 11:47 |
NREL Phase VI Geometry
|
#1 |
New Member
Eslam Hashem Mohamed
Join Date: Oct 2013
Location: Cairo,Egypt
Posts: 13
Rep Power: 12 |
I'm asking for a Geometry for NREL Phase VI wind turbine to do my case validation. I tried to sketch it but unfortunately i found that it contains some defects. Please if anyone have this geometry, i will be grateful if he send it.
one of the issues that made sense of conflict that the blade tip angle is set to 3 degree towards the feather (towards wind direction) from the rotor plane. while in the table describing the Blade chord and twist distributions shows that a negative twist angle starting from 3.781 til the tip. I made my model like this table but i don't know how to pitch the blade tip by 3 degree in the same time. Eslam |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modeling a two phase flow in a concentric cylindrical geometry | rshbhb | FLUENT | 4 | June 30, 2021 16:42 |
alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 16:12 |
Simulation of NREL UAE Phase VI turbine | aqstax | FLUENT | 63 | June 25, 2014 10:28 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Geometry setup for phase change problem | Fred G. Kang | Main CFD Forum | 1 | October 14, 1998 11:41 |