CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   How to sketch from a picture in Design Modeler (https://www.cfd-online.com/Forums/ansys-meshing/142367-how-sketch-picture-design-modeler.html)

jatin1990 September 29, 2014 06:03
How to sketch from a picture in Design Modeler
 
Greeting, I have a job in hand to draw a simple 2d sketch from a picture given. That picture is actually the contact area between Chip-Work piece-Tool interface for single point cutting tool during cutting operation on a lathe machine. Please someone help me whether its feasible in Ansys Design modeler or not?

Thank you.

engineer.iman September 30, 2014 02:32
Quote:
Originally Posted by jatin1990 (Post 512301)
Greeting, I have a job in hand to draw a simple 2d sketch from a picture given. That picture is actually the contact area between Chip-Work piece-Tool interface for single point cutting tool during cutting operation on a lathe machine. Please someone help me whether its feasible in Ansys Design modeler or not?

Thank you.
can you provide a picture of that!
i find design modeler very convenient with simple to moderate geometries


All times are GMT -4. The time now is 17:47.