Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

question about wind turbine blade geometry in Ansys

Mark Forums Read

Reply

Search this Thread

October 5, 2014, 22:42	question about wind turbine blade geometry in Ansys	#1
afshar6263 New Member omid Join Date: Oct 2014 Posts: 1 Rep Power: 0	Hi, My research is defined to wind turbine modeling. At the first time, I am just wondering to know, how should I design geometry model of wind turbine model through the Design Modeler page? It would be appreciated if anyone advise me step by step of that. Thank you

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[TGrid] Water Turbine meshed in TurboGrid: Geometry and Topology issues	ama294	ANSYS Meshing & Geometry	12	September 29, 2014 13:23
how to stimulate wind turbine in ANSYS fluent	er_ijaz	FLUENT	0	July 13, 2013 02:05
Verifying results for a wind turbine blade simulation in ANSYS CFX	Joystix	CFX	3	April 27, 2012 17:52
Wind turbine GEOMETRY	James Hetfield	Main CFD Forum	2	November 1, 2011 01:09
Wind tunnel of a turbine blade tests.	Jonas Pedro Caumo	CFX	3	April 28, 2007 02:35

All times are GMT -4. The time now is 03:46.