[ICEM] joining mesh

zdunol · October 12, 2014, 20:08

Hello gentlemen.
I don't know how to "join" two blocks that i meshed. I am not sure how to explan this properly but when I export the mesh to the fluent i get a line (wall boundary) between top middle block and the one in the bottom. I just dont knot how to put two meshes from two blocks into one ;(
thanks in advance

When i simply try to merge them I get error "merge region not structured".

hwet · October 13, 2014, 22:23

easy, in ansys design modeller select the two different parts and make them a single part (select both by control key and then right click to see the option)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Star CCM Overset Mesh Error (Rotating Turbine)	thezack	Siemens	7	October 12, 2016 11:14
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

October 13, 2014, 22:23		#2
hwet Senior Member Join Date: Mar 2014 Posts: 375 Rep Power: 13	easy, in ansys design modeller select the two different parts and make them a single part (select both by control key and then right click to see the option)