CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Mesh quality (https://www.cfd-online.com/Forums/ansys-meshing/143443-mesh-quality.html)

hans.siddharth October 24, 2014 14:30
Mesh quality
 
Hi guys, are mesh aspect ratio, orthogonal quality and skewness the only factors at the end of the day which decide whether a mesh is good or not? If no what are the other factors?
Pardon me if this is a stupid question. Just a beginner :)

amin.z October 27, 2014 10:09
Quote:
Originally Posted by hans.siddharth (Post 515932)
Hi guys, are mesh aspect ratio, orthogonal quality and skewness the only factors at the end of the day which decide whether a mesh is good or not? If no what are the other factors?
Pardon me if this is a stupid question. Just a beginner :)
Hey!
All of them are important! If you read ANSYS meshing manual you will find some helpful guidance!

hans.siddharth October 27, 2014 10:12
Thanks alot amin! Will do that. :)


All times are GMT -4. The time now is 19:53.