|
[Sponsors] |
November 15, 2014, 00:16 |
Problem while extruding meshed circle
|
#1 |
New Member
Thomas Milin
Join Date: Aug 2014
Posts: 7
Rep Power: 12 |
Hi,
I have been tring to create a cylinder. My strategy is to create a circle, mesh it and then extrude it. But im facing problem during extruding. One sector is getting extruded in the opposite direction. On using the Blocking/Pre mesh parameters/Match edges option i was able to find that one edge shows opposite direction and it is the sector corresponding to this edge that is geeting extruded in opposite direction. I have tried many ways to corrrect this issue but to no avail. Your expert guidance will be most appreciated. Thank You |
|
Tags |
cylinder, extrusion, meshing |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 11 | September 4, 2024 05:28 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 08:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 20:42 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |