|
[Sponsors] |
November 16, 2014, 08:43 |
Sharing Faces, no connection
|
#1 |
New Member
Lukasz
Join Date: Nov 2014
Posts: 1
Rep Power: 0 |
Hi guys.
I'm struggling with problem about connection of the mesh in Ansys. I have the face as in the picture that i split with plane. Just to get as much conformal mesh as it can be achieved. I mean using the size edge. But the problem is that there is no connection between this faces. Im not familiar with the root of that problem. 1. I designmoduler all that faces are in the one part. 2. And the mesh still brake in connections between those faces. Someone have idea what to do ? Of course shared topology is set to : |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 09:23 |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 91 | December 21, 2022 04:50 |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |