Modeling half a sphere
 

Hello, I need to model half a hollow sphere, like a dome, like a sphere within a sphere and the fluid is going to flow through the space (2cm) between the 2 spheres. Where can i find a tutorial or which tool can i use for it in designmodeler ansys.

thank you.:(

Hi Orvic,

two ways to do it
1. Create>Primitives>Sphere
2. Revolve a 180 degree arc, not a circle

create two spheres one inside other with Thin/Surface = Yes
Once these two spheres are created you can create>slice from the center.


Hope it helps

Cheers
Kapi