 |
 |
 |
|
|
|
[Sponsors] | ||||
December 20, 2014, 23:31
|
curving an edge within the same plane
|
#1 |
|
Member
Abdulaziz Abutunis
Join Date: Aug 2014
Posts: 43
Rep Power: 11  |
Hi all,
Please need help for a problem. I am trying to curve edges using split edge with spline method. The curves looked fine but they deviate from the plane they were created in first time. I tried to associate the edges to the geometry surface and use automatic linear but that did not work. Please any suggestion is appreciated Thank you |
|
|
|
|
 |
| Tags |
| curving edges, deviation from the plane, split edge spline |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| Poor Residuals at Intersection Between Symmetry Plane and Airfoil Leading Edge | TWaung | CFX | 2 | February 16, 2010 08:11 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
