|
[Sponsors] |
December 23, 2014, 09:47 |
Narrow Y geometry meshing
|
#1 |
Senior Member
Govindaraju
Join Date: Apr 2010
Posts: 209
Rep Power: 17 |
Dear all
I am trying to mesh a narrow Y type geometry. I want to create further block one of the sides of "V". When I create block on one side of "V" both sides have been selected. Is there any way to suppress other side . Thank you Govind |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Meshing of Simple 2D Geometry | harman79 | FLUENT | 2 | January 17, 2018 06:07 |
Gambit meshing problem to following geometry | ahmadmln | ANSYS Meshing & Geometry | 2 | October 21, 2014 01:49 |
[ANSYS Meshing] Using more than one meshing method on a single 2D geometry | robbierich90 | ANSYS Meshing & Geometry | 0 | October 30, 2011 13:12 |
Need help on meshing this simple geometry | nha1g08 | ANSYS Meshing & Geometry | 3 | March 9, 2011 02:13 |
meshing geometry in gambit | soundar | FLUENT | 1 | January 7, 2005 02:59 |