|
[Sponsors] |
[ICEM] how to mesh this with multi block structured gird |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 28, 2014, 00:19 |
how to mesh this with multi block structured gird
|
#1 |
Senior Member
|
i wan to mesh this boiler with a multiblock structured grid system.
Could you give me som suggestions about how to split it. Regards |
|
January 2, 2015, 06:09 |
|
#2 |
Senior Member
|
Hi,
I didnt try anything..i am just saying from the top of my head..hope it gives you some better idea/direction. If not please excuse me.. After creating a block for the outermost cylinder, keep splitting the edges so that you have one block for each smaller pipes. You can do this by splitting two adjacent edges of the original block twice each and then select the four edges together and associate it to the pipe. Hope it gives you some idea bye |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Mixer mesh - negative volume problem | jadtwo | OpenFOAM Meshing & Mesh Conversion | 2 | November 6, 2014 16:37 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |