|December 31, 2014, 12:49||
Join Date: Dec 2014
Posts: 4Rep Power: 4
Hi everyone, I'm currently in the midst of redo-ing my meshing however I have encountered a problem that I would like to seek for your help. Below are the details:
Pictures shows the mesh that I have done up with my geometry. I understand that multi-zone and sweep function would enable me to obtain a better quality mesh however ANSYS Meshing does not allow me to select either the multi-zone and sweep function for my geometry. I also did up using Tetra however the skewness level was above 0.99 and I was unable to obtain a residual value of -0.4 for continuity.
Hence, do you guys have any solutions/advice to create a better mesh for such geometry? Or Is there any way for me to use the multi-zone of sweep function for my geometry?
Thank you in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|3D Hybrid Mesh Errors||DarrenC||ANSYS Meshing & Geometry||11||August 5, 2013 06:42|
|[ICEM] Generating Mesh for STL Car in Windtunnel Simulation||tommymoose||ANSYS Meshing & Geometry||48||April 15, 2013 04:24|
|2D Mesh Generation Tutorial for GMSH||aeroslacker||Open Source Meshers: Gmsh, Netgen, CGNS, ...||12||January 19, 2012 04:52|
|engrid -> save as .stl with boundarie codes||Zymon||enGrid||31||August 29, 2011 13:40|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|