Need advice with meshing of conical body
1 Attachment(s)
Hello there, I have been using ICEM CFD for a while and conical body meshing has always been a problem for me. Recently, I tried to create a model of a half conical body. The image of the model is attached below.
If I were to use basic splitting and association techniques, the result will be a mesh with bad quality at area near the pointy tip of the cone. Perhaps, anyone know a better technique ? |
Pointy resolution?
Hello there - I am curious to know if you have ever resolved your issues with meshing the "point".. I am having similar issues...
Kind regards, Tom. |
Quote:
|
Quote:
|
All times are GMT -4. The time now is 18:41. |