|
[Sponsors] |
January 21, 2015, 19:16 |
General Question About Hybrid Meshing
|
#1 |
Member
Join Date: Jul 2012
Location: Wisconsin,USA
Posts: 34
Rep Power: 13 |
Hi guys,
Sorry if this is repetitive, but I have been unable to find a clear answer on the forum or anywhere else. I have a hex and tet mesh and want to merge these two meshes to make one volume mesh(or region) WITHOUT the resulting shell elements at the interface. Is it possible ? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
general rule of thumb for bi-exponential meshing | hippiekyle | Mesh Generation & Pre-Processing | 1 | February 11, 2013 03:44 |
[ANSYS Meshing] Hybrid meshing ICEM | djoul | ANSYS Meshing & Geometry | 2 | January 17, 2012 18:18 |
[ANSYS Meshing] 2D airfoil hybrid meshing help! | gusdlsrb | ANSYS Meshing & Geometry | 0 | March 27, 2011 15:31 |
General question concerning porous domain | Boris Tobias | CFX | 0 | November 19, 2010 04:13 |
hybrid meshing for 3D wing | Angela Bong | Main CFD Forum | 0 | March 17, 2006 08:13 |