 |
 |
 |
|
|
|
[Sponsors] | ||||
February 6, 2015, 11:06
|
Partial cut off at trailing edge
|
#1 |
|
New Member
Gilberto Santo
Join Date: Apr 2012
Location: Gent (Belgium)
Posts: 18
Rep Power: 15  |
Hello everyone,
I am pretty new to TurboGrid and I am trying to build up a mesh for testing a wind turbine blade. The fact is that this blade has a cut-off trailing edge just close to the root, while close to the tip the trailing edge is unique. Is it still possible to create such a geometry in TG? If yes, how? I can't really specify the TE and LE in the curve file, since I have more than 500 profiles! Thanks in advance! |
|
|
|
|
 |
| Tags |
| cut-off, trailing edge, turbogrid, wind turbine |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| [DesignModeler] Creating a blunt trailing edge from collapsed leading edge | gmd | ANSYS Meshing & Geometry | 0 | March 2, 2012 10:48 |
| [ICEM] Hole near sharp trailing edge of airplane/wing geometry | jlichtwa | ANSYS Meshing & Geometry | 2 | September 21, 2010 16:19 |
| Which trailing edge is correct for meshing of aerofoils for CFX | LSC | CFX | 0 | May 10, 2009 13:45 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
Linear Mode
