Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[DesignModeler] is it possible to create an interface inside closed-loop geometry?

Updated Threads

Reply

Search this Thread

December 29, 2017, 16:31	is it possible to create an interface inside closed-loop geometry?	#1
s1291 Member Join Date: Aug 2017 Location: Algeria Posts: 98 Rep Power: 8	I am trying to simulate closed-loop wind tunnel in 2D. I want to model the fan as "Fan boundary condition". According to Ansys documentation the Fan must be modeled must be modeled as the interface between cells http://www.afs.enea.it/project/neptu...ug/node254.htm. AFAIK, in Design Modeler I can only create two surfaces, and specify the second surface as a Fan zone, then I have to change it to interior in Fluent (but in this case I have two interfaces). Can you tell me how can I create the geometry with only one interface as illustrated in the image below? Thank you https://ibb.co/d53vgb __________________ "When in doubt, use brute force." -- Ken Thompson Last edited by s1291; December 29, 2017 at 22:41.

Reply

Tags

design modeler, geometry fluent

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh can't create refimenet region	clktp	OpenFOAM Meshing & Mesh Conversion	3	February 27, 2022 09:26
zone-surface: cannot create surface from sliding interface zone. Creating empty surfa	sihaqqi	FLUENT	0	December 28, 2013 05:27
[blockMesh] Include list of points	Hikachu	OpenFOAM Meshing & Mesh Conversion	0	June 20, 2011 09:03
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

All times are GMT -4. The time now is 18:21.