|
[Sponsors] |
[Workbench] how can I have 2D regular mesh in ansys workbench? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 11, 2015, 14:24 |
how can I have 2D regular mesh in ansys workbench?
|
#1 |
New Member
Amir-hossein Mokhtari
Join Date: Mar 2015
Posts: 13
Rep Power: 11 |
Hello, I'm training Cavity by upper moving wall in Ansys workbench 14.5 . there is a problem in meshing the rectangular which is made in "design modeler" part. I utilized "sizing" method for meshing and then by "number of division" part with 40 divisions, subtilize that I selected all of the four sides. But my meshes are not regular. how can I have regular meshes?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transfer mesh from ansys workbench to maxwell | davidsve | ANSYS | 2 | June 11, 2018 03:42 |
importing mesh from Gambit and other software to ansys workbench | mortazavi | ANSYS Meshing & Geometry | 5 | June 6, 2011 11:09 |
Ansys workbench CFX Mesh | Tom | ANSYS Meshing & Geometry | 22 | December 1, 2010 21:34 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |