|July 15, 2015, 06:05||
Meshing complex geometry using hexa with single blocking
Join Date: Apr 2015
Posts: 10Rep Power: 3
hi, well i am a begineer in ICEM. i have to mesh the geometry of nozzle and substrate assembly using ICEM CFD. i need to mesh it using hexa. is it possible to mesh it using a single block then splitting. if i initialize different block for different parts then i incur problemn in merging vertices and i am doubtful weather the blocks are connected.
Last edited by piyupant; July 21, 2015 at 03:39.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Hexa meshing of impeller and diffuser assembly||Nitin Dewangan||ANSYS Meshing & Geometry||14||September 13, 2016 09:41|
|[ANSYS Meshing] Blocking and Meshing around a vane vortex generator||Crank-Shaft||ANSYS Meshing & Geometry||5||January 18, 2016 00:29|
|[ICEM] Hexa dominant meshing||Pat84||ANSYS Meshing & Geometry||19||December 2, 2015 18:20|
|[ANSYS Meshing] Complex 3D Hexa Meshing||pereiraICL||ANSYS Meshing & Geometry||0||October 24, 2011 11:10|
|3D wing + wind tunnel hexa structured meshing||icemaniac178||ANSYS Meshing & Geometry||9||October 28, 2010 09:37|