[GAMBIT] Size Function

aja1345 · July 20, 2015, 06:48

Hi dear friends

I want to use size function in Gambit, But I don't know that why does not Gambit apply this command. Please see the dbs file in the following attachment. For example, I want to get fine meshes around of face. 2.

How should i obtain values of Start size and Max. size until i can write these values correctly? I am grateful guide me about these values.

Best regards,

Amir

aja1345 · July 20, 2015, 09:41

Friends, Excuse me

I studied the tutorial about this subject and so, I understood.

First, I should create size function and then I mesh model.

aja1345 · July 20, 2015, 11:21

Hi,

Is this tool only for mesh of Tet/hybrid-TGrid? I want to use this tool for structure mesh. how to do?

thanks,

aja1345 · July 21, 2015, 16:13

Can no-one guide?

ghost82 · July 28, 2015, 10:16

Hi,
it works with hexa mesh too.
As you can see in the attached picture, from left to right:
- source:edge propagation to volume
- source:face propagation to volume
- source:vertex propagation to volume

Daniele

-mAx- · August 3, 2015, 01:03

As complement of Daniele's post:
https://www.sharcnet.ca/Software/Gam...ommands_create

August 3, 2015, 01:03		#6
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	As complement of Daniele's post: https://www.sharcnet.ca/Software/Gam...ommands_create aja1345 likes this. __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ParaView for OF-1.6-ext	Chrisi1984	OpenFOAM Installation	0	December 31, 2010 06:42
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
Compilation errors in ThirdPartymallochoard	feng_w	OpenFOAM Installation	1	January 25, 2009 06:59
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
size function	Rana	FLUENT	2	October 10, 2006 02:28

July 20, 2015, 09:41		#2
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Friends, Excuse me I studied the tutorial about this subject and so, I understood. First, I should create size function and then I mesh model.

July 20, 2015, 11:21		#3
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Hi, Is this tool only for mesh of Tet/hybrid-TGrid? I want to use this tool for structure mesh. how to do? thanks,

July 21, 2015, 16:13		#4
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Can no-one guide?