 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Cannot import import complete edges from spaceclaim |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 7, 2015, 15:33
|
Cannot import import complete edges from spaceclaim
|
#1 |
|
Member
Arvind Jay
Join Date: Sep 2012
Posts: 96
Rep Power: 14  |
I am tying to import a model created in ANSYS SDCM V16.0.
I could import the 3D model without any issues, but the edges on the body surface is only partially imported. And this is causing the ANSYS mesher to fail. Please see the attached picture. Thanks. |
|
|
|
|
|
August 10, 2015, 02:09
|
|
#2 |
|
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13 |
That edge is no good anyways. Use virtual topology to get rid of it, or use the geometry repair features in design modeler.
|
|
|
|
|
|
|
| Tags |
| ansys meshing, spaceclaim |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 09:12 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Linear Mode
