[ANSYS Meshing] Combine solid mesh generated in workbench mesh and fluid mesh in fluent meshing ?

RPjack · August 19, 2015, 18:12

This is a cohesive heat transfer analysis involve several solid and one fluid region. Initial mesh was generated in workbench mesh. However mesh in the fluid region cause iteration problems. (See https://www.dropbox.com/s/5ga2bnep39tqkmh/1mesh-cross-section.PNG?dl=0)

So I imported mesh generated from workbench mesh into Fluent meshing (Tgrid), Used auto mesh to generate the mesh for the whole part. Mesh in the fluid seems better, But mesh in the solid is bad
(See https://www.dropbox.com/s/r52q0u7iwpinv48/4.png?dl=0)

Can I keep the sweep mesh in the solid and only remesh the fluid region in Tgrid? Or is there a way to generate sweep solid mesh in Tgrid?

The solid parts and fluid share the same interface (identical surface mesh) for the purpose of cohesive heat transfer analysis.

Thanks for helping!

RPjack · August 19, 2015, 18:17

Advice on how to generate good mesh involve several solid body (rectangular shape solid except heat sink) and a fluid region for cohesive heat transfer analysis is greatly appreciated!

Far · August 27, 2015, 09:33

did you solve your problem ?

August 19, 2015, 18:12	Combine solid mesh generated in workbench mesh and fluid mesh in fluent meshing ?	#1
RPjack New Member Jackie Stan Join Date: Jul 2015 Posts: 3 Rep Power: 10	This is a cohesive heat transfer analysis involve several solid and one fluid region. Initial mesh was generated in workbench mesh. However mesh in the fluid region cause iteration problems. (See https://www.dropbox.com/s/5ga2bnep39tqkmh/1mesh-cross-section.PNG?dl=0) So I imported mesh generated from workbench mesh into Fluent meshing (Tgrid), Used auto mesh to generate the mesh for the whole part. Mesh in the fluid seems better, But mesh in the solid is bad (See https://www.dropbox.com/s/r52q0u7iwpinv48/4.png?dl=0) Can I keep the sweep mesh in the solid and only remesh the fluid region in Tgrid? Or is there a way to generate sweep solid mesh in Tgrid? The solid parts and fluid share the same interface (identical surface mesh) for the purpose of cohesive heat transfer analysis. Thanks for helping!

August 19, 2015, 18:17	How to generate good mesh for Fluent cohesive heat transfer analysis	#2
RPjack New Member Jackie Stan Join Date: Jul 2015 Posts: 3 Rep Power: 10	Advice on how to generate good mesh involve several solid body (rectangular shape solid except heat sink) and a fluid region for cohesive heat transfer analysis is greatly appreciated!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 06:20
[ANSYS Meshing] Solid inside Fluid - Multizone meshing	supercolli	ANSYS Meshing & Geometry	2	July 9, 2014 13:20
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 22:56
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

August 27, 2015, 09:33		#3
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	did you solve your problem ?