|
[Sponsors] |
[DesignModeler] Importing profile of wind tunnel |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 19, 2015, 08:52 |
Importing profile of wind tunnel
|
#1 |
New Member
Matvey
Join Date: Jun 2015
Posts: 1
Rep Power: 0 |
Hello everybody!
I have following problem: I have a profile of wind tunnel in .txt ( x,y,z coordinates), I found only one way to import this profile into designmodeler - create a 3D curve and specify .txt file (#group #point #x #y #z). After creating body by revolve function I have successfully generated mesh, but when I'm trying to launch "setup" in workbench the following error happens "System.ApplicationException: Application Error in CFX-Pre: ERROR There was a problem importing the mesh from the requested file. The importing process reported the following problem: Model "Model" does not have a valid mesh associated with it. Body B12 is an unsuppressed surface body that does not enclose a volume. Only 3D volume meshes can be imported. If your model contains valid bodies as well as surface bodies then suppress the surface bodies and remesh before continuing." So, the question is - how can I import the profile to DesignModeler and create valid body and then mesh associated with body? Thank you for answers |
|
August 28, 2015, 08:45 |
|
#2 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
are you working with ansys workbench? sometimes workbench (CFX-Pre) has weird hiccups when you change the geometry afterwards.
Workaround: Save the settings in CFX-Pre (*.ccl), close CFX-Pre, right-click on Pre in workbench and 'reset'. then start pre again and import the ccl file. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simulating wind shear profile for a wind turbine--> How??? | mohammad | CFX | 14 | August 25, 2014 09:09 |
simulating wind shear profile for a wind turbine--> How??? | mohammad | FLUENT | 0 | April 14, 2012 23:54 |
Simulate the wind profile on a wind turbine---> HOW ???? | mohammad | Main CFD Forum | 0 | April 13, 2012 08:16 |
Simulate the wind profile on a wind turbine---> HOW ???? | mohammad | Main CFD Forum | 0 | April 13, 2012 08:07 |
defining velocity profile in a wind tunnel model | Erdem | FLUENT | 0 | June 20, 2006 13:00 |