|
[Sponsors] |
September 9, 2015, 02:07 |
Prism ortho weight option removed
|
#1 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 733
Rep Power: 25 |
Hi,
In ICEM CFD v16.1 the ortho weight option has been removed from Mesh > Global Mesh Parameters > Prism Meshing Parameters. I am not going to install v16.2, so it may also be missing there as well and I cannot recall if it was in v16.0. Was this a mistake by the developers or has the feature been intentionally removed, if so what is the alternative? Thanks |
|
September 9, 2015, 02:50 |
|
#2 | |
Senior Member
Join Date: Feb 2011
Posts: 496
Rep Power: 18 |
Quote:
|
||
September 9, 2015, 04:10 |
|
#3 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 733
Rep Power: 25 |
Well spotted. So it been moved all the way down to the Smoothing Options. In v15.0 and older it was listed between Min Prism Quality and Fillet Ratio further up the list.
|
|
September 9, 2015, 06:52 |
|
#4 |
Senior Member
Join Date: Feb 2011
Posts: 496
Rep Power: 18 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |