|
[Sponsors] |
October 6, 2015, 17:56 |
Boundary conditions mess
|
#1 |
New Member
Abdalla
Join Date: Oct 2015
Posts: 2
Rep Power: 0 |
Hello guys,
I am not really good at fluent but I have been working on something pretty simple and it is not going well. I am using workbench to simulate a nozzle, my problem is after I insert named selections for my inlet, outlet, and walls and go from meshing to fluent they do not show up in boundary condition section for some reason. Does anyone know what am I screwing up? Thanks, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
inlet boundary conditions | newOFuser | OpenFOAM | 1 | January 10, 2013 08:08 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |