Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] How to set the no.of nodes on edges as a function of edge length?

Mark Forums Read

Reply

Search this Thread

October 13, 2015, 09:38	How to set the no.of nodes on edges as a function of edge length?	#1
shivasluzz Senior Member sluzzer Join Date: Jul 2014 Posts: 146 Rep Power: 13	Is it possible to set the number of nodes any edge as a function of length of corresponding edges? Just like, no. of nodes = 2* edge length

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] Errors during blockMesh meshing	Madeleine P. Vincent	OpenFOAM Meshing & Mesh Conversion	51	May 30, 2016 11:51
[ICEM] Very weird, pre-mesh does not generate volume mesh after setting nodes on some edge.	sharonyue	ANSYS Meshing & Geometry	0	April 30, 2015 13:06
ParaView for OF-1.6-ext	Chrisi1984	OpenFOAM Installation	0	December 31, 2010 07:42
Compilation errors in ThirdPartymallochoard	feng_w	OpenFOAM Installation	1	January 25, 2009 07:59
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

All times are GMT -4. The time now is 00:02.