 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] ICEM-uncovered faces due to refinement |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 4, 2015, 03:15
|
ICEM-uncovered faces due to refinement
|
#1 |
|
Senior Member
Anton Kidess
Join Date: May 2009
Location: Germany
Posts: 1,377
Rep Power: 29  |
I have a mesh out of hexas with refinement. Between two levels of hexes a layer of cube-shaped polyhedrals is placed. Unfortunately CFX cannot deal with those, so I want to split up the polys. I tried using the "Resolve refinements" function of ICEM, but I get a "This mesh has no couplings" error (the mesh was not generated in ICEM). I also tried the "Fill holes in volume mesh" function of the Delaunay mesher, but I still end up with uncovered faces. Does anyone know how to solve the problem?
http://imgur.com/RCDdWns
__________________
*On twitter @akidTwit *Spend as much time formulating your questions as you expect people to spend on their answer. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 14:53 |
| [snappyHexMesh] snapEdge - failure | Tobi | OpenFOAM Meshing & Mesh Conversion | 33 | March 18, 2014 03:58 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
Linear Mode
