|
[Sponsors] |
November 6, 2015, 03:41 |
Negative Volume!!
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
It is created the negative volume in the following geometry. Why? Please see volume 67. http://www.4shared.com/zip/hS41qJnCc...ells-SRF5.html I am grateful that guide me about this case. Thanks. Best. Aja |
|
November 6, 2015, 07:02 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
go in examine mesh and select "volume" as Type.
Then Gambit will automatically set the lower and upper values in both slider. You are right you have some negative volume cells. Set now the upper value to 0 and press enter. Gambit will show you where they are. Untitled.jpg Untitled1.png My advice: add more nodes an edge 592 especially in the middle
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
multiphase turbulance case floating error | harsha_kulkarni | OpenFOAM Running, Solving & CFD | 3 | February 18, 2016 05:06 |
[ICEM] negative sector volume | adam2008 | ANSYS Meshing & Geometry | 0 | August 9, 2014 00:24 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
remeshing due to negative volume error | Doginal | CFX | 1 | August 21, 2011 21:50 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |