[ANSYS Meshing] Smoothening ofSharp Edges for easy Meshing

Saksham Bhutani · November 26, 2015, 15:01

This is Saksham Bhutani, final year IIT-BHU Civil Engineering Student. I have to do analysis of steel wire mesh on ANSYS.

I am facing an issue in meshing due to sharp edges. Its like 4-5 circular pipes are meeting at a point and sharp angles and edges are created which is restricting the structure to get meshed.

Is there any way out?

-Maxim- · November 27, 2015, 05:31

could you please upload a screenshot of your problem/mesh?
Are you using prism layers (inflation)? What are your meshing parameters?

Saksham Bhutani · November 28, 2015, 07:56

I am not able to mesh because of hard edges at intersection. Yes I am using prism layers. We shall use the meshing parameters suggested by u. As of now I have applied general meshing with given the size.

Also can u tell me how to apply mass operation like blend on all edges?

November 26, 2015, 15:01	Smoothening ofSharp Edges for easy Meshing	#1
Saksham Bhutani New Member Saksham Bhutani Join Date: Nov 2015 Posts: 2 Rep Power: 0	This is Saksham Bhutani, final year IIT-BHU Civil Engineering Student. I have to do analysis of steel wire mesh on ANSYS. I am facing an issue in meshing due to sharp edges. Its like 4-5 circular pipes are meeting at a point and sharp angles and edges are created which is restricting the structure to get meshed. Is there any way out?

November 27, 2015, 05:31		#2
-Maxim- Senior Member Maxim Join Date: Aug 2015 Location: Germany Posts: 413 Rep Power: 14	could you please upload a screenshot of your problem/mesh? Are you using prism layers (inflation)? What are your meshing parameters? Saksham Bhutani likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops	avinashjagdale	OpenFOAM Meshing & Mesh Conversion	53	March 8, 2019 10:42
[ANSYS Meshing] How to not consider all edges during meshing	RodriguezFatz	ANSYS Meshing & Geometry	19	November 26, 2015 08:39
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09