 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Enclosure and Geometry Setting |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 28, 2015, 10:19
|
Enclosure and Geometry Setting
|
#1 |
|
New Member
Habibullah
Join Date: Oct 2015
Posts: 6
Rep Power: 10  |
Untitled.png
As Shown in the Screen shot the circle denotes the enclosure or Domain. But the placement of the geometry inside the enclosure or Domain is wrong because it is not present in the centre or middle of the enclosure Or Domain.......... So how we can set the geometry in the centre or Middle of the Domain?????????????????? |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Fill tool - grouping the faces of a complicated geometry? | HeikkiT | ANSYS Meshing & Geometry | 8 | July 20, 2016 07:37 |
| [DesignModeler] Enclosure (cylinder body) around imported geometry | executor | ANSYS Meshing & Geometry | 4 | March 29, 2016 12:08 |
| [DesignModeler] Enclosure and Geometry | habibullah | ANSYS Meshing & Geometry | 1 | November 13, 2015 05:41 |
| Geometry Enclosure | habibullah | CFX | 3 | November 9, 2015 05:07 |
| [Other] Problematic Geometry- meshing with enclosure. | lev1athan | ANSYS Meshing & Geometry | 2 | February 24, 2012 16:24 |
Linear Mode
