|December 2, 2015, 06:37||
The mesh file exporter does not support overlapping geometry in contact regions.
Join Date: Mar 2015
Posts: 1Rep Power: 0
I have made a simple tube in which water is flowing inside it. Then I have enclosed my geometry to add air around it. I did the meshing and there was no error in it. But while updating I got "The mesh file exporter does not support overlapping geometry in contact regions. Please resolve the issue and try again.". How do I resolve this error?
Thanks in advance and best regards,
|December 2, 2015, 20:12||
Join Date: Apr 2014
Location: Not Sure
Posts: 508Rep Power: 6
-go to Mesh<Show<Overlapping geometry
You should be able to see problematic geomtry, if not then change View<Wireframe to see
-Check your named selection, most likely you have named select same edge/face/body twice
Also, Before asking any question please "search" similar questions for your answers. This question has been asked multiple times before.
|Thread||Thread Starter||Forum||Replies||Last Post|
|groovyBC in openFOAM-2.0 for parabolic velocity bc||ofslcm||OpenFOAM Pre-Processing||24||August 23, 2015 22:41|
|Adding solvers from DensityBasedTurbo to foam-extend 3.0||Seroga||OpenFOAM Installation||9||June 12, 2015 17:18|
|Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12||keepfit||OpenFOAM Paraview & paraFoam||60||September 18, 2013 03:23|
|build problem swak4Foam OF 2.2.0||mcathela||OpenFOAM Installation||14||April 23, 2013 13:59|
|DecomposePar links against liblamso0 with OpenMPI||jens_klostermann||OpenFOAM Bugs||11||June 28, 2007 17:51|