Overlapping Named Selection error though every named selection differs from each othe
Hi,
I am working on 3D heat exchanger flow fluid analysis. on photo below I have uploaded is relevant to overlapping name selection that I have never made same named selection in same geometry face/edge/vertex How could it possibly to happen even if I could not give any same named selection? Moreover all tubes have been picked up together and all tubes is intersection to outer region that I make design Thanks in Advance https://imageshack.com/i/paX0frrbp |
seems you have used same face or edges in two different named selection.
Check your named selection one by one and see which two named selection highlights this face/edge! remove it form one or other named selection!! sorted! cheers KAPI |
All times are GMT -4. The time now is 05:20. |