|
[Sponsors] |
[ANSYS Meshing] 3D Inflation mesh around tubes in other fluid domain |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 12, 2015, 20:49 |
3D Inflation mesh around tubes in other fluid domain
|
#1 |
Member
Onur
Join Date: Sep 2015
Posts: 42
Rep Power: 10 |
Hi,
I am working on a system having two fluid domain. As shown two photos. https://imageshack.com/i/p8dhfNHxp https://imageshack.com/i/pbWuwIfqp in outer tubes domain, other fluid domain is available and I would like to have boundary layer around tubes ( outer side).But I couldnt do that as you see 2 photos, What should I do? Multizone, sweep? if it is so, what exactly should I do? I have used inflation mesh in that part.and around circular ( around diameter of tubes) I have selected edge sizing but I have never seen that . And another thing, (system has multi-part exported 3D cad programme) there is a cat-part on waste gas fluid domain.Face below cat part has boundary layer both around tubes and inner tubes.But contrary there is no way to see photos that I have uploded. Kind Regards, |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Boundaries of Overlapping Solid Mesh in Fluid Domain Being Ignored | rap4957 | ANSYS Meshing & Geometry | 0 | September 16, 2015 19:29 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 10:55 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |