Structural Mesh on Compressor
5 Attachment(s)
Dear All,
I am working with centrifugal compressor stage. I have used blocking method to put mesh on diffuser part of centrifgual compressor stage. The mesh look fine, but when I go and look at the quality of the mesh, it shows the element having uality ever lower than 1, as shown in the attached figure. Furthermore, the aspect ratio is higher 5 in thousands. Can anyone please advise, what step shall I choose to improve the quality. I am very much struglling. Ansys CFX is accepting this kind of mesh. I have attached few figures that might help in elaborating the respected request. Please help!!! Many thanks, |
Can anyone please help with the aforementioned thread.
|
All times are GMT -4. The time now is 19:37. |