CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] 2D Split Edges on ANSYS Design Modeler (https://www.cfd-online.com/Forums/ansys-meshing/166184-2d-split-edges-ansys-design-modeler.html)

yomilayeni February 4, 2016 07:21

2D Split Edges on ANSYS Design Modeler
 
I tried splitting one side of my 2D model by first selecting the 2D edge in sketching mode, but the Split Edges in the Concept menu was not highlighted for selection. How do I do this?


All times are GMT -4. The time now is 18:59.