[ANSYS Meshing] First Aspect Ratio Inflation control missing in ANSYS Meshing?

spggodd · February 10, 2016, 18:43

Hi,

I am using ANSYS Meshing for a 2D geometry but the option to set an inflation layer by First Aspect Ratio is not available.

Can anyone advise me on how to get the first aspect ratio option?

Thank you
Steve

spggodd · February 12, 2016, 14:05

Can anyone help me with this?

bjc8z · February 23, 2016, 19:52

If you change your assembly method to CutCell I believe it will be available then.

spggodd · February 23, 2016, 20:52

I will try it out tomorrow! Thanks for replying, much appreciated!

Kapi · February 23, 2016, 23:16

you should get First Aspect Ratio inflation option with "Patch Conforming Method" as well.

February 10, 2016, 18:43	First Aspect Ratio Inflation control missing in ANSYS Meshing?	#1
spggodd Member Steven Goddard Join Date: Mar 2015 Posts: 34 Rep Power: 9	Hi, I am using ANSYS Meshing for a 2D geometry but the option to set an inflation layer by First Aspect Ratio is not available. Can anyone advise me on how to get the first aspect ratio option? Thank you Steve

February 23, 2016, 19:52		#3
bjc8z New Member Brian Connolly Join Date: May 2015 Posts: 3 Rep Power: 9	If you change your assembly method to CutCell I believe it will be available then. spggodd likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help me to choose between Ansys Meshing, Fluent Meshing or ICEM ?	pipolaki	ANSYS	0	December 6, 2013 09:12
High Aspect Ratio elements	Flavio	CFX	2	November 24, 2006 13:01
Missing tets along line when meshing with ICEM CFD	Georges P. Côté	CFX	6	March 23, 2006 01:34
does aspect ratio affect analysis	mahesh	Main CFD Forum	2	October 10, 2005 10:12

February 12, 2016, 14:05		#2
spggodd Member Steven Goddard Join Date: Mar 2015 Posts: 34 Rep Power: 9	Can anyone help me with this?

February 23, 2016, 20:52		#4
spggodd Member Steven Goddard Join Date: Mar 2015 Posts: 34 Rep Power: 9	I will try it out tomorrow! Thanks for replying, much appreciated!

February 23, 2016, 23:16		#5
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 12	you should get First Aspect Ratio inflation option with "Patch Conforming Method" as well.