[ICEM] Ogrid "copy to parallel edges" issue

gggiulio · February 17, 2016, 08:11

Hello everybody.

This is my first post in cfd-online, I apologise for any error I can make.

I am also quite new in usign Icem, I did many tutorials on youtube, and those suggested by the forum. But couldn't find any solution to my problem:

I have a geometry with a hole with a ogrid around. No problem in blocking.
when I want to set edge parameters, it somehow recognizes all parallel edges around the hole, even if I have cancel the block....
A pic may clarify my issue....

Hope you could find some time to reply...

Thank you in advance,
Giulio

-Maxim- · February 18, 2016, 10:17

what exactly is your question? what are you trying to archive?

gggiulio · February 18, 2016, 10:20

I would like to have an O-GRID with different number of elements on each side (4 sides each different number of elements).

-Maxim- · February 18, 2016, 10:25

did you uncheck/deselect 'copy to parallel edges'?

gggiulio · February 18, 2016, 11:10

Actually, yes. I tried all the options, in particular "copy to selected edge", but it automatically selects all parallel edges (like if instead of a hole there was a block, which is not...)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] shm in parallel with simple decomposition	mihaipruna	OpenFOAM Meshing & Mesh Conversion	6	July 16, 2015 04:55
Can not run OpenFOAM in parallel in clusters, help!	ripperjack	OpenFOAM Running, Solving & CFD	5	May 6, 2014 15:25
parallel Grief: BoundaryFields ok in single CPU but NOT in Parallel	JR22	OpenFOAM Running, Solving & CFD	2	April 19, 2013 16:49
IcoFoam in parallel Issue with speed up	hjasak	OpenFOAM Running, Solving & CFD	19	October 11, 2011 17:07
parallel issue: global face zone/patch ...	matteoL	OpenFOAM Running, Solving & CFD	2	June 16, 2010 06:22

February 18, 2016, 10:17		#2
-Maxim- Senior Member Maxim Join Date: Aug 2015 Location: Germany Posts: 415 Rep Power: 12	what exactly is your question? what are you trying to archive?

February 18, 2016, 10:20		#3
gggiulio New Member Giulio Join Date: Feb 2016 Location: Birmingham Posts: 13 Rep Power: 10	I would like to have an O-GRID with different number of elements on each side (4 sides each different number of elements).

February 18, 2016, 10:25		#4
-Maxim- Senior Member Maxim Join Date: Aug 2015 Location: Germany Posts: 415 Rep Power: 12	did you uncheck/deselect 'copy to parallel edges'?

February 18, 2016, 11:10		#5
gggiulio New Member Giulio Join Date: Feb 2016 Location: Birmingham Posts: 13 Rep Power: 10	Actually, yes. I tried all the options, in particular "copy to selected edge", but it automatically selects all parallel edges (like if instead of a hole there was a block, which is not...)