[ANSYS Meshing] ICEM mesh is not smooth!

zhaomu67 · February 22, 2016, 02:05

hello, i would like to do a 3d simulation of flow around a circular cylinder, but i'm having some problems in the circle, i associated four edges of the square to the circle. but there are some problems! the mesh around circle is not smooth enough.

piyupant · March 1, 2016, 07:42

check, whether u have associated the edge-curve correctly.

Far · March 1, 2016, 08:50

Quote:

Originally Posted by zhaomu67

hello, i would like to do a 3d simulation of flow around a circular cylinder, but i'm having some problems in the circle, i associated four edges of the square to the circle. but there are some problems! the mesh around circle is not smooth enough.

It is the problem of association

February 22, 2016, 02:05	ICEM mesh is not smooth!	#1
zhaomu67 New Member Join Date: Nov 2014 Posts: 8 Rep Power: 11	hello, i would like to do a 3d simulation of flow around a circular cylinder, but i'm having some problems in the circle, i associated four edges of the square to the circle. but there are some problems! the mesh around circle is not smooth enough.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
FLUENT - ICEM / Segmentation Violation Error (Hybrid Mesh)	Joachim	ANSYS	3	April 24, 2016 16:52
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?	jash	ANSYS Meshing & Geometry	19	July 23, 2013 18:48
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM	kawamatt2	ANSYS Meshing & Geometry	17	December 20, 2011 11:45
ICEM 10 mesh question	DAK565656	CFX	6	May 8, 2007 12:16

March 1, 2016, 07:42		#2
piyupant New Member Piyush Join Date: Apr 2015 Location: Kolkata Posts: 12 Rep Power: 11	check, whether u have associated the edge-curve correctly.